Faster:

The reversed angle matches up with the pad of your thumb sooner than the factory button. You will find the gun in your hand just by grabbing it.  Weak side draw becomes much faster as well. 


More Reliable:

The wider release button means you have even less potential to miss the activation, especially on thigh rigs or mounting systems that push the holster away from your body.

If you have ever found yourself  pulling up on the gun before hitting the release you've noticed that gun is difficult to almost impossible to get out. The additional leverage of the Nub Mod fixes this stress induced or poor training problem if it ever arises due to the increased surface area for the thumb to engage. 


Stronger:

Many find the button too small and glue or plastic weld onto the button to make it larger. This has the potential to make the typical homemade button get pushed over into the body of the holster rendering it inoperable. 

The machined aluminum piece is indexed in part by the outside edge of the factory button. It will not come over the edge of the holster. It is bead blasted then hard anodized.  

 

Simple Install:
Simply press the larger nub piece over the factory button from the inside of the holster.  Align the smaller narrow piece with the top of the larger one. Insert screw and tighten with supplied allen wrench.  You may add Loc Tite or finger nail polish to the threads if desired.  See notes at base of page on fit. 

Holster types and fit:

1911 users must use a 1911 Nub Mod, which is compatible with 1911 Level I holsters. 

The ALS Nub Mod will only work with Level I ALS holsters.  For Level III holsters with the SLS hood and the ALS Lever, use our SLS Nub Mod. 

The older style ALS holsters that have the 'step' (see image below)  into the holster body  will require a fair amount of filing to get the fit right.


Common Sense Warning:
If you are worried about someone taking your gun from you this would make that easier. Obviously anything that makes it easier for you will make it easier for your enemy.  If you simply want to keep your gun in your holster while doing whatever it is you do,  and still be able to get it out fast without going through multiple levels of retention, the ALS only and Nub Mod are probably just what you are after.



6354DO holster photo courtesy of Milspecmonkey.com

1911 Nub Mod shown above

*Works with Level I only*

Below is the older style that will require a fair amount of work to make the Nub Mod fit.  This style was made before 2008.  

If you are worried that the button is too large and your gun may fall out, consider this: I wear mine woodcutting, backpacking with my kids, fence building, driving trucks and skid steers, and even sometimes when working out outside between shooting drills (Burpees, flutter kicks pushups etc). It has never come out of the holster until I wanted it to. The thigh rig in the picture to the right is what I use doing all those activities, with a spray painted prototype nub on it.  This does not mean you should not prove YOUR holster with YOUR gear!

Also, the Safariland 7TS material has proven very consistent in varying temps: Hunting cougars all day in 5*F weather, the material barely contracts. Compare this to other holsters that 'freeze' and make the draw much different in varying temperatures. 


Disclaimer: Any reference to Safariland or the ALS/Automatic Locking System are registered Trademarks of The Safariland Group.

Purchase 1911 Nub Mod

Made in the USA!

Patent Pending

Also available at: